Results for "oil-filter"

Engine Hard 4-6 hours 310 👍 0

Ford F53 7.5L RV Won't Start: Fuel Pump Relay Voltage Drop Fix

Woke up to my 1996 Ford F53 7.5L motorhome eating through my patience and wallet with this no-start issue that keeps coming back. It cranks strong but absolutely will not start, and I've been chasing this problem for weeks now. The engine ran fine for about 3-4 minutes one day, then just died and hasn't started since.

I've already done quite a bit of diagnostic work:
- Replaced PCM and distributor
- Fuel pump works when powered directly
- Battery is fully charged
- Checked fuses and relays
- PCM relay voltage drops from 12.2V to 9.3V with key on
- Fuel pump relay only shows 3.3V at pin 86 (should be 12V)
- Inertia switch tested at 1.7V at connector
- ANL 178 fusible link fluctuates between 0.3-0.6V

The engine will only start with starter fluid when the SPOUT is removed. I'm getting only 5.5V at the fuel pump connector.

Has anyone dealt with this specific issue on an F53 chassis? I really need to get this RV back on the road and I'm running out of ideas! …more

Read answer

Engine Easy 45 min 248 👍 0

Femco vs Fumoto Oil Drain Valves for RVs - Which is Better?

Looked at my mechanic's quote for a $300 professional oil change setup and something seems off—wouldn't a basic Femco or Fumoto drain valve work just fine? I've narrowed it down to Femco and Fumoto, but I'm genuinely worried about road debris damage since RVs sit lower and encounter more hazards than regular vehicles.

The thought of a drain valve getting hit by rocks or debris and causing a catastrophic oil leak on the highway keeps me up at night. I need to know which design is actually safer and more protected in RV applications. Does one have better protection features than the other? I'd rather be overly cautious than deal with a roadside emergency. …more

Read answer

Exterior Medium 2-3 hours 214 👍 1

How to Replace RV Slide Topper Fabric: Complete DIY Guide 2024

I pulled into three different campsites this month and my torn slide topper is eating through my gear faster than I can replace it. I've never done anything like this before and I'm worried I might damage the whole mechanism or make things worse.

Can I actually replace just the fabric portion safely, or should I bite the bullet and have the entire assembly replaced by a professional? I'm also concerned about costs - I'm hoping this won't break the bank. If it is something I can do myself, how difficult is it really? I don't want to get in over my head and end up with a bigger problem than I started with.

Can you help me understand the best approach for my specific situation? …more

Read answer

Product Ranking 8 compared

Best RV Awnings & Accessories

4.5 (7,600 reviews)

Engine Hard Not recommended 207 👍 0

Ford V10 Turbo Kit for Motorhomes: Cost, Risks & Better Alternatives

Before every camping season rolls around, I face the same dreaded reality with my Ford V10 motorhome crawling up mountain passes like a wounded turtle. What are the realistic costs involved? Are there major risks to the engine I should know about? Is this actually worth doing or should I look at other options? …more

Read answer

Exterior Medium 30-60 min 196 👍 1

Kwikee RV Steps Not Working? Complete Troubleshooting Guide (2024)

Apparently we're leaving for a three-week cross-country trip next Monday and my Kwikee electric RV steps are still having intermittent retraction issues even after replacing both the gear box and motor. My steps are exhibiting intermittent retraction issues - they extend normally but require manual assistance to retract fully, stopping approximately a quarter inch through the cycle without intervention. I've already installed a new gear box and motor, yet the problem persists.

What systematic diagnostic approach should I follow to identify the root cause? I need to understand the complete troubleshooting sequence for motor functionality, electrical switch operation, and mechanical linkage components. Are there specific voltage measurements, resistance checks, or mechanical adjustments that should be performed to isolate whether this is an electrical or mechanical failure?

Thanks,
Pete …more

Read answer

Slideouts Medium 2-3 hours 153 👍 0

RV Slide Out Moving Slowly? Complete Lubrication & Repair Guide [2024]

I tried everything I could think of, but after all that heavy rain last week, my slide out went from smooth operation to moving like molasses. It sounds like it's really struggling and straining, making these awful grinding noises that have me worried I'm going to break something expensive.

I've been reading that lubrication might be the answer, but I honestly don't know where to start. Should I be looking at the motor mechanism? The tracks? I've heard about hydraulic fluid but I'm not sure if my system is hydraulic or electric. I really need someone to walk me through what needs lubrication and what else I should check before this thing stops working completely!

Could you help me troubleshoot? Details that might help: Can you tell me the specific model of my RV and the type of slide out system it uses? …more

Read answer

Electrical Medium 45 minutes 153 👍 0

RV Shore Power Not Working: Complete Troubleshooting Guide

Plugged into shore power at the campground last night and absolutely nothing happened — no lights, no AC, nothing. Breaker on the pedestal looks fine and my neighbor's rig is running perfectly on the same circuit. Starting to wonder if something fried inside the transfer switch. …more

Read answer

Ac Refrigeration Medium 45 minutes 152 👍 0

How to Fix a Squeaking Dometic Fan-Tastic Roof Fan in Your RV

Looked up at my Dometic Fan-Tastic roof fan squeaking loudly above my kids' beds—is this dangerous or could something actually break and fall on them? The fan blades aren't hitting the housing, so that's not the issue. What are the most common causes of squeaking in these roof fans? Is this something I can fix myself with basic maintenance, or does it usually require replacing parts like bearings or the motor? …more

Read answer

Engine Hard Professional repair required 149 👍 0

Ford F53 V8 Engine Tapping Noise: Complete TSB 25-2200 Repair Guide for RV Owners

Since I replaced the valve cover gaskets on my 2022 motorhome's Ford F53 V8 yesterday, I'm still hearing that annoying tapping noise — did I miss something? I've been noticing this tapping or ticking sound when the engine is idling, and sometimes it seems to run a bit rough. I'm worried I might have a serious problem.

I found a Ford Technical Service Bulletin (TSB 25-2200, NHTSA ID 11018524) that might be related to my issue. The bulletin mentions potential camshaft and valve tappet wear causing ticking noises, rough performance, and diagnostic trouble codes P0301-P0308. According to the bulletin, repairs might even include a new long block.

Can someone help me understand what this TSB covers exactly? Does it apply to my specific year model, and what kind of repairs might be needed? I'm hoping this might be something covered under warranty since the RV is still pretty new to me.

Any guidance would be really appreciated - I'm still learning about all this mechanical stuff! …more

Read answer

Electrical Medium 2-4 hours 140 👍 0

How to Protect Your RV Alternator When Charging Lithium Batteries: DC-

Tried everything my neighbor did to charge his LiFePO4 batteries but mine keeps frying the alternator while his works flawlessly — what's different? I want to install a temperature sensing device that can interrupt charging by opening the solenoid between chassis and house charging systems if the alternator gets too hot. I'm looking to spec out components and understand the installation process, and I'm open to hearing why this might not be a good approach. My goal is preventing alternator overheating when these lithium batteries draw high current compared to my old flooded or AGM batteries. I'm looking for technical feedback and am totally open to critique. …more

Read answer

Plumbing Easy 30 minutes 138 👍 0

How to Fix Stuck RV Toilet Valve After Winterization - Step by Step

Called a repair shop about my RV toilet valve that only gets stuck when it's above 60 degrees outside — works perfectly fine during colder weather after winterization. During the camping season, my toilet works perfectly fine - the dump valve opens and closes smoothly without any problems. However, after I winterize my RV for winter storage and drain all the water from the system, I consistently run into the same frustrating problem when I try to de-winterize in spring.

The toilet dump valve gets completely stuck in the closed position and requires significant force to get it moving again. It seems like the valve mechanism seizes up during the months of storage when there's no water in the system. I'm assuming this happens because the seals and moving parts dry out completely without any moisture present during winter storage.

What's the best preventive maintenance I can do to keep this valve from sticking during winterization? Are there specific lubricants or treatments I should apply to the valve mechanism and seals before putting the RV into storage? I'd rather prevent this problem from happening in the first place rather than having to force a stuck valve every spring and risk damaging the toilet. …more

Read answer

Product Ranking 8 compared

Best RV Leveling Blocks & Jacks

4.6 (9,800 reviews)

Chassis Medium 45 minutes 133 👍 0

Dutchstar Chassis Cracking Noise: Diagnosis & Repair Guide

Hearing a loud cracking or popping noise from underneath my Dutchstar when going over bumps or turning. Sounds structural — like metal flexing or a weld breaking. Crawled under and couldn't see any obvious cracks but the noise is getting louder each trip. …more

Read answer

Engine Medium 3-4 hours 132 👍 0

Cummins ISL Code 1896: EGR Valve Controller Gaskets & Repair

About to drop $2,800 on my Cummins ISL throwing code 1896 for EGR valve controller out of calibration and wondering if I can tackle this myself. Planning to pull and clean the EGR valve controller to see if that clears it up.

Do I need to order replacement gaskets before I start this job? Want to make sure I have everything on hand before I tear into it. …more

Read answer

Exterior Medium 2-3 hours 132 👍 0

Dometic 8300 Series Awning Torsion Assembly Replacement Guide (834AV44

Already burned through three Dometic 8300 torsion assemblies in six months and I'm hemorrhaging money as a new RV owner. The model number is 834AV44.138 and I'm not even sure what series this is - is it part of the 8300 series maybe?

The torsion assembly lever broke off and I can't seem to find exact replacement parts anywhere. I'm wondering if there are compatible parts from other Dometic awning models that would work with mine? I don't want to order the wrong thing and make the problem worse. Any guidance on finding the right replacement parts or temporary fixes would be really helpful! …more

Read answer

Plumbing Medium 1-2 hours 129 👍 0

RV Tank Sensor Removal Guide: Gray & Black Water Tank Sensors (Step-by-Step Process)

Somewhere between throwing $150 at new RV tank sensors and just ripping out these faulty gray and black water sensors completely, I'm wondering which route makes more sense? Was looking at changing my gray/black water tank sensors, but when I crawled under there, this is what I found. What kind of sensors are these and how do you remove them? I'd really appreciate some specific advice about the sensor type and removal technique. …more

Read answer

Loading more Q&A...

You've seen all 107 Q&A articles!