Results for "kwikee"

Plumbing Medium 1-2 hours 222 👍 0

Monaco Diplomat Rear Air Suspension Won't Dump Fully - Troubleshooting Guide

Last week my 2006 Monaco Diplomat's rear air bags started refusing to dump all the way down when I hit the air dump before leveling. The front dumps fine, but the back stays partially inflated.

I'm still pretty new to RV maintenance and not sure where to start troubleshooting this. Should I be hearing air escaping when I activate the dump? What are the most common causes when rear air bags won't dump completely? Any guidance on what to check would be really appreciated! …more

Read answer

Exterior Medium 30-60 min 196 👍 1

Kwikee RV Steps Not Working? Complete Troubleshooting Guide (2024)

Apparently we're leaving for a three-week cross-country trip next Monday and my Kwikee electric RV steps are still having intermittent retraction issues even after replacing both the gear box and motor. My steps are exhibiting intermittent retraction issues - they extend normally but require manual assistance to retract fully, stopping approximately a quarter inch through the cycle without intervention. I've already installed a new gear box and motor, yet the problem persists.

What systematic diagnostic approach should I follow to identify the root cause? I need to understand the complete troubleshooting sequence for motor functionality, electrical switch operation, and mechanical linkage components. Are there specific voltage measurements, resistance checks, or mechanical adjustments that should be performed to isolate whether this is an electrical or mechanical failure?

Thanks,
Pete …more

Read answer

General Easy 20 min research 189 👍 0

How to Find Reliable RV Repair Shops: Expert Tips & Red Flags to Watch Out For

About every summer my 2004 Adventurer runs like a dream until temps hit 85°F, then it breaks down constantly and no shop can figure out why. The main slide out has been acting up with the HWH hydraulic system, and I honestly don't know enough to fix it myself.

I'm worried about getting taken advantage of since I don't really know what questions to ask or what warning signs to watch out for. I've heard horror stories about people paying huge bills for shoddy work. What's the best way to research and find a reliable shop? Are there specific things I should ask them before I commit to having work done?

Any guidance would be really appreciated - I just want to make sure I'm being smart about this and not walking into a bad situation. …more

Read answer

Product Ranking 8 compared

Best RV Propane Accessories

4.5 (11,200 reviews)

General Easy 30 min maintenance 175 👍 0

RV Slide-Out Maintenance: Complete Guide to Prevent Wear and Extend Lifespan

Before I even finish extending my 2018 Newmar 2702 slide-out, there's this grinding vibration that kicks in during the final positioning phase every single time. The motor works hardest during that last foot of travel when the slide settles into place.

This observation has me questioning optimal maintenance protocols for slide-out longevity. What are the most effective strategies for reducing mechanical wear on these systems? I'm particularly interested in understanding proper usage frequency, seal maintenance requirements, and whether partial extension during routine tasks like cleaning provides any protective benefits.

Looking for comprehensive guidance on preventive maintenance practices, lubrication schedules, and storage considerations that will maximize slide-out system lifespan while minimizing premature component failure. …more

Read answer

Slideouts Medium 1-2 hours 136 👍 0

Fleetwood Bounder Slide Out Reset: Fix Lost Stop Points & Controller Issues

Slide out lost its stop points during a power surge at the campground and now it extends way too far and retracts too deep. Fleetwood Bounder forum says I need to reset the controller but the process involves running the slide to its limits and I'm afraid of damaging the mechanism. …more

Read answer

General Medium Varies by issue 130 👍 0

How to Fix RV Slide Out Topper Awning Problems: Common Issues and Solutions for Smooth Operation

Before buying our first RV, I never even knew slide topper awnings existed, and now ours is acting up and I'm completely lost. We're having all three slide toppers professionally replaced next week, but I'm honestly worried we'll end up with the same problems all over again if they're not installed properly.

I've been reading horror stories about misaligned toppers, wrong spring tension, and fabric bunching up during slide operation. Since this is costing us a pretty penny, I really need to know what specific things I should insist the installer check and test before they leave. What are the critical adjustments that need to be made during installation to prevent these common topper problems from happening again? …more

Read answer

Engine Medium 1-2 hours 118 👍 0

Ford F53 Chassis Bump Stop Replacement - Missing or Broken Front Leaf

Despite replacing F53 chassis bump stops twice already this season, my 2021's driver's side front leaf spring bump stop has completely vanished again and I'm done guessing. Just... gone. Vanished into the ether.

I'm seeing a bunch of aftermarket polyurethane bump stops on Amazon and other places, but honestly not sure if I should just bite the bullet and get the Ford OEM part or if there are better options out there. Also wondering if I should be checking the other side too - seems like these things might be prone to failing?

Anyone dealt with this before? What's the move here - stick with factory or upgrade to something beefier? …more

Read answer

General Easy 1-2 hours 111 👍 0

How to Replace Kwikee Super Slide II Drive Wheels - Step-by-Step DIY Repair Guide

Planning to tackle my Kwikee Super Slide II drive wheel replacement myself versus paying a shop $300+ after they started making that awful metal-on-metal chattering noise. I've found pieces of old rubber near the slides where it's completely broken off the wheel cores.

I've looked into replacement OEM parts which cost around $75 per wheel, and I would need 8 wheels replaced. I've discovered a DIY repair method using a PMC-790 urethane rubber kit that could potentially fix this for much less. The total repair materials cost me about $134, compared to $600 for new wheels.

My repair process involved creating custom molds using 2-inch PVC test caps, 2.5-inch and 5/8-inch hole saws, and mixing urethane rubber in a specific 2:1 ratio. I even added blue colorant for fun. Has anyone else tried a similar approach to restoring these drive wheels? …more

Read answer

Exterior Medium 1-2 hours 107 👍 0

Kwikee Steps Won't Extend: Complete Troubleshooting & Repair Guide

Every time I open my RV door these Kwikee steps stay stuck at 90% retracted — should I drop $300+ on replacements or try fixing first?

I'm pretty sure this is either a motor that's given up the ghost or something's binding up in the linkage, but I'd love some confirmation before I start throwing parts at it. Should I be checking for 12V at the motor first, or am I overthinking this? And while we're at it, any preventive maintenance I should do to keep this from happening again? Because apparently my RV has commitment issues with working components. …more

Read answer

Exterior Medium 1-2 hours 104 👍 0

RV Electric Steps Won't Lock Extended - Troubleshoot Lock Switch & Control Board Issues

Noticed my 2008 Tiffin Allegro Bay 35 TSB electric steps won't lock extended and keep retracting when I close the door — tackling this Saturday, what should I prep?

I'm concerned this could be a safety issue, and I don't want to start taking things apart without knowing what I'm doing. Could this be the lock switch going bad, or maybe something with the control board? I have a multimeter but I'm nervous about testing electrical components incorrectly. What's the safest way to troubleshoot this problem? …more

Read answer

General Easy N/A 83 👍 0

1996 Newmar Mountain Aire Diesel Pusher: Complete Owner's Guide & Maintenance Tips

Spent way too much time getting quotes and now I'm staring at $2,800 worth of repairs for my 1996 Newmar Mountain Aire on Ford F530 chassis. Recently, the RV was stored outside and squirrels caused wiring damage, which I've had repaired. Now I'm dealing with a problem where the lights stay on when the transmission goes into reverse. I've already checked the relays and fuses, and been told it might be a faulty reverse sensor, but I can't locate it or find a manual. I need help understanding: 1) What could be causing the reverse lights to stay on (I currently have to remove a relay to turn them off), and 2) Where I might find the reverse sensor on this transmission. Any guidance would be greatly appreciated. …more

Read answer

Loading more Q&A...

You've seen all 11 Q&A articles!