Results for "ground fault"

Engine Medium 2-6 hours 466 👍 1

Onan 5500 Generator Problems: Complete Repair Guide 2024

Spent three hours testing my 2014 Hurricane's Onan 5500 gen getting 11.8 volts output when every manual says it should be 12+ volts! Here's the weird part - when I disconnect the remote harness, the generator fires right up and purrs like a kitten. But the second I plug that remote connection back in, boom - both the remote start light AND the generator start light come on, and then... nothing. Won't start at all.

The really bizarre symptom is this chattering from the fuel pump when the remote is connected. I can literally feel the fuel line jumping around when I put my hand on it. It's like the pump is having some kind of seizure or something!

I'm guessing this has to be some kind of electrical issue between the control board and the remote system, but I've never seen anything quite like this before. Anyone dealt with this specific combo of symptoms on an Onan 5500? Really hoping there's a known fix because pulling this thing out of the RV again would be a major pain! …more

Read answer

Electrical Medium 2-6 hours 389 👍 4

RV Electrical Problems: 12V & 120V Troubleshooting Guide 2024

Around $500 in parts later — replaced the main breaker, cleaned all connections, checked the transfer switch — my 2007 Holiday Rambler Admiral SE still won't recognize shore power.

I'm pretty sure 110V is making it to the rig since I can measure it, but somewhere between the plug and my appliances, something's not happy. Energy management panel is dark too. What's the logical troubleshooting order here? I keep hearing about transfer switches and breaker panels but honestly don't know where to start without making things worse! …more

Read answer

Electrical Medium 2-6 hours 295 👍 1

ECM Low Battery Warning RV: Complete Diagnosis & Fix Guide

During a family trip, my 2005 Fleetwood Discovery 39S threw code 168-1 for low ECM battery voltage and went into full shutdown mode—is this dangerous with kids onboard? Engine cut out, transmission selector went dark, ABS warnings everywhere - the whole nine yards. Scared the heck out of me when it happened on the interstate!

I'm seeing this seems to be a thing with these diesel pushers, but I'm drowning in conflicting info online. Some say it's the chassis battery, others blame alternator issues, and I've even seen posts about ECM power supply problems on the Caterpillar engines. What's the actual step-by-step process to track this down? And more importantly, how do I fix it so it doesn't leave me stranded again? Really need a complete walkthrough of what causes this code and the proper repair approach. …more

Read answer

Product Ranking 8 compared

Best RV Water Heaters

4.4 (6,800 reviews)

Electrical Medium 30-90 min 190 👍 0

No 12 Volt Power in RV: Complete Troubleshooting Guide

Turned the key and nothing works on 12 volt — no lights, no water pump, no slides. Batteries show 12.6 volts on the multimeter so they're fully charged. House batteries seem fine but zero power is getting to any of the 12V circuits inside the coach. …more

Read answer

Electrical Easy 30 minutes 173 👍 0

RV 12V Lights Dimming: Complete Troubleshooting Guide

My neighbor insists it's the converter, the RV dealer swears it's bad wiring, and every YouTube video claims it's a dying battery—but my 12V ceiling lights keep dimming! One evening they're blazing bright like a casino, the next morning they're giving off all the enthusiasm of a sleepy firefly.

I've already checked my batteries, and they seem to be charging fine and in good shape. The converter is still humming and its fan is running normally. I'm pretty sure this isn't some fancy mood lighting feature I accidentally activated (though knowing my tech skills, anything's possible). The dimming seems totally random - sometimes they're fine, sometimes they look like they're on their last legs.

I've got a basic multimeter that I pretend to know how to use, but I'm not sure where to even start poking around. As a bonus weirdness, some of my under-cabinet light switches and the wall switch for the ceiling lights are getting really hot. Anyone know what typically causes this whole disco light show situation with 12V lighting systems? …more

Read answer

Ac Refrigeration Medium 2-3 hours for diagnosis, professional repair likely needed 161 👍 0

Coleman Mach AC Fuse Blows With Battery On - Rockwood Fix

Found out the hard way that the previous owner of my 2019 Rockwood Minilite 2509s left me with a Coleman Mach AC that blows fuses instantly when I flip on the battery. The AC fuse blows instantly when I turn on the battery disconnect, before the AC is even activated. The fuse literally blows before it's completely seated in the panel.

This began two weeks ago without warning - the system had been functioning normally prior to this. Initial fuse replacement provided temporary operation, but the problem returned on the next trip with the fuse already blown upon arrival.

Given the immediate fuse failure with just battery power connected, what type of electrical fault would cause this symptom pattern in a Coleman Mach unit, and what's the most likely location of the problem in the AC circuit? …more

Read answer

Solar Batteries Medium 45 minutes 158 👍 0

RV MPPT Solar Controller E1 Error Code: Causes & Fixes

Halfway through troubleshooting my MPPT solar charge controller's E1 error — would this be covered under warranty, or am I stuck paying out-of-pocket? The controller was working fine for months, but now it's completely stopped charging my batteries and just displays this E1 fault code on the screen.

From what I've read, this could be related to battery over-voltage conditions or possibly some kind of wiring fault, but I want to make sure I understand all the potential causes before I start troubleshooting. I'm comfortable doing basic electrical work myself, but I also want to know when this might be something that requires professional attention for safety reasons.

Can someone provide a detailed breakdown of what the E1 error specifically indicates, walk me through the proper diagnostic steps to identify the root cause, and explain the repair process? I'd especially appreciate guidance on how to safely approach this troubleshooting and what warning signs would indicate I should call in an expert instead of attempting the fix myself. …more

Read answer

Electrical Medium 45 minutes 153 👍 0

RV Shore Power Not Working: Complete Troubleshooting Guide

Plugged into shore power at the campground last night and absolutely nothing happened — no lights, no AC, nothing. Breaker on the pedestal looks fine and my neighbor's rig is running perfectly on the same circuit. Starting to wonder if something fried inside the transfer switch. …more

Read answer

Appliances Medium 2-4 hours 149 👍 0

RV Water Heater Not Hot Enough: Fix Lukewarm Water Issues

Looked forward to our two-week cross-country trip starting tomorrow until I discovered my RV water heater that used to produce scalding hot water now barely gets lukewarm. Both the electric and gas functions appear to be working - I can hear the gas igniting and see the electric indicator light - but the water temperature just won't get hot enough for a decent shower.

I've been dealing with this for weeks now and it's driving me crazy. The water gets warm, but nowhere near the hot temperatures I used to get. Is this a common problem with RV water heaters? What are the most likely culprits when you're getting lukewarm water instead of hot? I really need to figure out what's causing this and how to fix it before my next camping trip. …more

Read answer

Ac Refrigeration Medium 45 minutes 147 👍 0

RV AC Making Loud Humming Noise? Fix Compressor Not Starting

Somewhere above my head, there's this loud, relentless humming grinding through the RV whenever I flip on the rooftop AC — compressor won't start but the fan spins fine.

I've been dealing with this for days now and it's driving me crazy - especially with the heat we've been having! The humming is so loud that I'm worried something might be seriously damaged. I really hope this is something I can fix myself rather than having to call out a repair tech. What could be causing a compressor to hum loudly but not start up? …more

Read answer

Propane Medium 30-60 minutes 135 👍 1

Atwood AFMD35 Furnace Playing Peek-a-Boo - How to Clean Flame Sensor & Fix Short Cycling

Staring at my Atwood AFMD35 manual that claims it should stay running once lit, but mine keeps shutting off every few minutes like it's playing peek-a-boo. It fires up beautifully for about 5-10 seconds, gets my hopes up that I won't freeze tonight, then promptly shuts off like it's having second thoughts about this whole "heating the RV" thing.

I've ruled out the sail switch and high temp limit since it actually lights (small victories in RV life, right?). I'm pretty sure the flame sensor is the culprit here, but I've never cleaned one before. How do I clean this mysterious little part, and what's the best way to access it on this model? Because apparently my furnace thinks playing hard-to-get is charming! …more

Read answer

Product Ranking 8 compared

Best RV Awnings & Accessories

4.5 (7,600 reviews)

Electrical Medium 1-2 hours 131 👍 0

Why Your RV Trips GFCI at Home But Not Campground: Complete Troubleshooting Guide

Turned on my motorhome at 11 PM and it tripped the home GFCI again — works perfectly at campgrounds but I need this solved before departure.

I've tried different adapters, rewired a busted GFCI inside the rig, even turned off ALL the breakers including the main panel breaker. Still trips my house GFCI every time, whether it's the garage, side of house, or front outlets. What gives? Why would it work everywhere else but trip GFCIs at home? There's gotta be something specific causing this, right? …more

Read answer

Slideouts Medium 45 minutes 131 👍 0

RV Electric Leveling Jacks Won't Extend - Fix Clicking Issue

Wondering if I should drop $800 on new electric leveling jacks or if this annoying clicking issue can actually be fixed first? The jacks were working perfectly fine on our last camping trip about two weeks ago, but now when I try to extend them, I can hear a distinct clicking sound coming from the controller panel, yet none of the jacks actually move or extend. The clicking happens consistently when I press the extend button, so it seems like the system is trying to respond, but something is preventing the actual mechanical operation.

I'm wondering what the most common causes are for this specific symptom - where you get the clicking from the controller but no actual jack movement. I'd like to understand the logical troubleshooting sequence, starting with the easiest things to check first before I dive into more complex diagnostics. The RV has been sitting plugged into shore power, but I know these systems can have multiple potential failure points including electrical, hydraulic, or control issues.

What should I be checking first, and what's the typical progression for diagnosing electric leveling jack problems that manifest with clicking sounds but no extension? …more

Read answer

Propane Medium 45 minutes 131 👍 0

RV Furnace Blowing Cold Air? Fix Ignition Issues Fast

Staring at my RV furnace blowing cold air at 2 AM with the fan running — desperately need this fixed before morning hits.
I can hear it trying to ignite but it never actually lights. What are the most common causes when a furnace won't ignite? Need to know what components to check and how to diagnose ignition problems myself. …more

Read answer

Propane Medium 1-2 hours 130 👍 0

Dometic RV Furnace Runs 10 Seconds Then Shuts Off - Complete Troubleshooting Guide

The YouTube tutorials I followed to fix my Dometic DFMD35111 furnace that runs 10 seconds then dies actually made it worse—now it won't even start! Every time I try to run it, the same thing happens - it fires up, runs for exactly 10 seconds, then just shuts off completely. This has been going on for weeks now and I'm getting desperate since the weather is getting colder.

I've been trying to troubleshoot this myself but honestly don't know where to start. I can hear the blower running and the unit seems to ignite initially, but then it just dies. Is this a common problem with these Dometic units? I'm really hoping this is something I can fix myself rather than having to call out an expensive repair tech.

What are the most likely culprits when a furnace runs for just 10 seconds then shuts down? I need to know what components to check first before I start taking things apart. …more

Read answer

Loading more Q&A...

You've seen all 88 Q&A articles!