Results for "front end"

Engine Easy N/A 260 👍 0

Ford E-350 vs E-450 Chassis: RV Fuel Economy, Power & Weight Capacity

Last weekend I felt this awful engine strain and heard sluggish acceleration sounds while test-driving a 2017 Phoenix Cruiser #2351 with its E-350 chassis and V10 engine. I'll be doing extensive western touring through mountain and plains regions, which means substantial mountain grades and wind challenges. I'm comfortable driving slowly and want to understand two key things: 1) Will this E-350 chassis handle mountain grades without major issues, and 2) What's the real-world fuel consumption like? I plan to do an initial inspection this weekend, followed by a third-party mechanical review. I'm not overly concerned about fuel economy but want to understand the actual performance limitations. I'd appreciate insights from owners who have experience with similar touring conditions on an E-350 chassis. …more

Read answer

Plumbing Medium 1-2 hours 222 👍 0

Monaco Diplomat Rear Air Suspension Won't Dump Fully - Troubleshooting Guide

Last week my 2006 Monaco Diplomat's rear air bags started refusing to dump all the way down when I hit the air dump before leveling. The front dumps fine, but the back stays partially inflated.

I'm still pretty new to RV maintenance and not sure where to start troubleshooting this. Should I be hearing air escaping when I activate the dump? What are the most common causes when rear air bags won't dump completely? Any guidance on what to check would be really appreciated! …more

Read answer

Electrical Medium 1-2 hours research and setup 173 👍 1

Safari Motorcoach LPG Tank Refill for Stationary RV Setup

Between my toolbox and the YouTube tutorials I've watched, I'm ready to tackle the LPG tank refill setup on my permanently parked 2000 Safari Sahar 32-footer. Since my wife and I live in California and visit several times per year to help her aging parents, the RV serves as a stationary dwelling with full hookups for shore power and water.

The challenge is that the coach won't be moved to drive to propane filling stations, so I'm exploring on-site refill options. I'm specifically interested in potentially transferring propane from a standard 40lb grill tank to our RV's fixed tank. I want to understand what type of fitting our Safari Sahar has and what safety considerations or special equipment might be required for liquid-to-liquid propane transfer.

Since we'll need heating during colder months and my wife will sometimes be at the RV without me, I want to ensure a reliable and safe refill method. What are my options for refilling the LPG tank without moving the motorcoach? …more

Read answer

Product Ranking 8 compared

Best RV Air Conditioners

4.4 (8,100 reviews)

General Medium 4-8 hours 168 👍 0

How to Reduce RV Interior Noise: Complete Sound Dampening Guide for Motorhomes

Despite having a 2021 Coachmen Mirada, looking at my sound meter right now and there's 69 decibels of highway noise blasting through the cabin. My target is to achieve approximately 65 decibels for better communication with passengers.

I need a systematic approach to interior noise reduction. What are the most effective sound dampening materials and techniques for motorhomes? Specifically, I'm looking for solutions that address engine noise transmission, road noise, and any rattling components that contribute to the overall sound level.

What realistic noise reduction can I expect from proper sound deadening implementation, and what are the key areas to focus on for maximum impact? …more

Read answer

Engine Easy 15 minutes to inspect 165 👍 0

RV Tire Age Limits: Why Replace Michelin Tires After 7 Years Despite Good Tread

Called three different tire shops this month about my 2020 Newmar Ventana's Michelin 275/70R22.5 tires and all want them replaced just for being 6 years old despite perfect tread. I'm meticulous about tire maintenance - I check air pressure religiously before and after every trip, whether it's a short weekend getaway or an extended cross-country journey like the 5000-mile trip I just completed.

Despite my careful maintenance routine, I experienced a blowout on the right rear inside tire during the final leg of that recent long trip. When the roadside service technician came out to help, he recommended replacing all six tires specifically because of their age, even though the remaining tires still have plenty of tread depth and appear to be in excellent condition visually.

This has me confused because I've heard conflicting advice from other RV owners - some say well-maintained motorhome tires can safely last up to 10 years, while others insist on much shorter replacement intervals. I'm trying to understand what the actual safety guidelines are for RV tire replacement based on age versus tread wear. Should I really replace tires that still look good just because of when they were manufactured? What's the real story on how tire age affects safety, and how do I properly check the manufacturing date to make this decision? …more

Read answer

Exterior Medium 45 minutes 146 👍 0

RV Awning Won't Extend or Retract: Complete Troubleshooting & Repair Guide

This power awning manual says hold the extend button for 3 seconds, but mine's completely dead and won't budge no matter how long I hold it. When I hit the extend button, it moves out maybe 6-8 inches and then immediately retracts on its own. I have to turn the power switch off and back on each time to get even that little bit of movement.

I'm hesitant to keep forcing it since I don't want to burn out the motor or make whatever's wrong even worse. Could this be an electrical issue with low voltage, or maybe the tracks are too dirty? I've also heard about limit switches causing problems but I'm not sure how to check those safely.

What are the most common causes when an awning does this short extend-then-retract cycle? I want to start with the safest troubleshooting steps before calling a repair shop. …more

Read answer

Chassis Medium 45 minutes 133 👍 0

Dutchstar Chassis Cracking Noise: Diagnosis & Repair Guide

Hearing a loud cracking or popping noise from underneath my Dutchstar when going over bumps or turning. Sounds structural — like metal flexing or a weld breaking. Crawled under and couldn't see any obvious cracks but the noise is getting louder each trip. …more

Read answer

Engine Easy 20 min read 130 👍 0

RV Wheel Alignment Guide: Warning Signs, Cost & When to Get Service

This Class A Freightliner Chassis alignment I finished yesterday still pulls hard left through those tight campground turns — did I mess something up? who knew? 🙄

Now I'm dealing with some funky tire wear patterns and my rig seems to have developed a mind of its own on the highway - it's pulling to one side like it's trying to make an unscheduled scenic detour. I'm pretty sure I need a wheel alignment, but honestly, I have no clue what warning signs to look for or how often this service should be done.

What are the telltale signs that scream 'GET AN ALIGNMENT NOW!'? I'm specifically looking for recommendations near Glendale, AZ, and I've heard mixed things about Bell Road RV. How do I find a shop that actually knows what they're doing with big rigs like my Freightliner? And what should I expect to pay for this delightful reality check? Any guidance would be awesome before I end up as one of those viral RV fail videos! …more

Read answer

Chassis Medium 3-4 hours 128 👍 0

2003 Ford F53 RV Chassis Wheel Bearing Grease Guide - Best Products &

I'm wondering if my grease choice is wrong for my 2003 Ford F53's front bearing replacement when my neighbor's identical motorhome runs perfectly after his service. The original grease that came out was a dark gray/black color and while there wasn't any catastrophic damage, the races showed enough wear marks that I decided to replace everything while I'm in there.

I've been researching different options and keep seeing conflicting recommendations. Some people swear by standard lithium grease, others recommend full synthetic formulations, and I've even seen mentions of specific brands like Valvoline MaxLife and Timken. I know the F53 chassis carries significantly more weight than a typical pickup truck, so I want to make sure I'm using something that can handle the load.

I have the torque procedure down (30 ft-lbs initial, back off, then final setting at 17 in-lbs), but I want to make sure I'm pairing that proper installation with the right grease. What specific grease products work best for the F53 front wheel bearings, and are there any compatibility issues I should be aware of when selecting a replacement grease? …more

Read answer

Chassis Hard Research and planning phase 127 👍 0

Ford F53 Godzilla V8 Suspension Problems: Fixes & Upgrades for Class A Motorhomes

Halfway through my first long trip, this bone-rattling vibration and unsettling sway started plaguing my newer Class A motorhome with the Ford F53 Godzilla V8 chassis. Coming from a 26' travel trailer and a history with brands like LazyDaze, I'm trying to understand the current RV landscape. I saw a Baystar 2023 model where the owner spent around $35,000 on suspension upgrades after just 12,000 miles.

Sounds awesome on paper, but I keep hearing people say you still need to dump a ton of money into suspension upgrades to make these things handle decently on the highway. Did Ford actually improve the suspension setup when they introduced the Godzilla engine, or are we dealing with the same basic chassis design that's been around forever? I'm talking about 30+ foot Class A rigs here - seems crazy that a $200k motorhome would need immediate aftermarket work to drive safely.

Anyone know if the Godzilla F53 combo actually fixed the handling problems or if it's just more power on the same wobbly platform? …more

Read answer

Slideouts Easy 30 minutes inspection 126 👍 0

RV Hydraulic Leveling Jack Leaks: Normal Seepage vs Serious Problems Explained

Somewhere between parking and leveling my 2019 Forest River Georgetown, I noticed the hydraulic leveling jacks have small amounts of fluid on the fittings. No puddles underneath and the jacks aren't sagging when stored or in use. Just a light coating on the hoses and one fitting has a small amount of fluid visible.

Is this normal seepage or something I should worry about? What's the difference between normal weeping and a real problem that needs immediate attention? …more

Read answer

Product Ranking 8 compared

Best RV Propane Accessories

4.5 (11,200 reviews)

Engine Medium 2-4 hours for custom fabrication 123 👍 0

F53 V10 Water Ingestion Fix When Ford Parts Discontinued

Our '99 F53 chassis with the V10 engine hasn't run right ever since we got caught in that torrential downpour last month and now we're dealing with water ingestion issues. I've experienced hydro-lock issues in severe downpours, and I know Ford issued Technical Service Bulletin 04-24-22 specifically addressing this air intake design flaw on the '99 to '04 F53 models. The TSB called for replacing the air intake horn and modifying the intake strap to prevent water from being sucked into the engine during heavy rain conditions.

The problem is that when I contacted my Ford dealer, they told me the critical air intake horn part specified in TSB 04-24-22 has been discontinued and is no longer available. The modified strap is still available, but without the new intake horn design, I'm still vulnerable to water ingestion during storms. With extensive travel plans ahead where I'll likely encounter severe weather, I need a reliable solution to protect my engine from hydro-lock.

What are my options for addressing the F53 V10 water ingestion problem when the original Ford TSB parts are no longer available? Are there aftermarket solutions or modifications that other F53 owners have successfully implemented to solve this issue? …more

Read answer

Slideouts Medium 2-3 hours 121 👍 0

HWH RV Slide Hydraulic Hose Repair: Complete DIY Guide

Replaced my HWH slide's hydraulic hose last month and now it's spraying fluid everywhere again with our three-week cross-country trip starting Friday! My 2007 Monaco Dynasty with HWH hydraulic system decided to throw me a curveball when the bedroom slide hydraulic line (1/4" I.D.) decided to spring a leak. After some detective work (and a lovely puddle of ATF to mark the spot), I traced it back to where a 1" air line to the front caliper had been playing the world's slowest game of 'saw through the hydraulic hose' for who knows how many miles.

I temporarily patched with Gorilla Tape and 1/2" hose clamps, which got the slide almost closed but still creeping. I'm planning to fix this with a compression coupling since that seems like the most straightforward approach for a DIY repair. Two quick questions: Can anyone confirm the 1/4" I.D. hose size for HWH systems? And once I get this coupling installed, will I need to bleed the system, or does it sort itself out? I'm hoping this repair goes smoother than my attempts to explain to my spouse why we're currently camping with a slide that's permanently 'almost' closed! …more

Read answer

Slideouts Medium 2-4 hours 120 👍 0

Lippert Power Gear Slide Motor Replacement: Complete Guide to Parts &

Walked out to prep our RV this morning and discovered our Lippert Power Gear slide motor is making grinding noises and won't extend properly. My RV's slide motor is failing and I'm trying to figure out the best way to get replacement parts. The slide is getting sluggish and I suspect it's either the motor brushes or possibly something in the gearbox itself.

I've been searching everywhere for Lippert Power Gear parts but I'm not sure where to look or what my options are. As it stands, the replacement parts are ridiculously expensive - a $100 gearbox, $50 brake, and $100 motor, but Lippert wants nearly $1000 for the whole assembly. I just want to replace the brushes, but they won't even sell those separately!

Can I buy just the motor component, or do I need to replace the entire gearbox assembly? I really need to know where I can actually purchase these parts and how to determine whether it's a motor issue or a gear problem before I spend a fortune on the wrong repair! …more

Read answer

Engine Easy Research and appointment 119 👍 0

F53 Motorhome Wheel Alignment Florida: Where to Find Heavy-Duty Service Experts

Standing here looking at my F53 motorhome for the third time this year needing wheel alignment and I'm absolutely done with tire shops saying they can't handle it. I recently had six new tires and Retrobands installed at NIRVC in Georgia, along with some suspension upgrades, and now I'm in the Gainesville, Florida area for the winter. My 12'-8" tall Class A seems to be too heavy for standard alignment equipment.

I'm trying to figure out what type of shops actually have the heavy-duty equipment needed for F53 chassis alignment. Are there specific places I should be looking for, or am I gonna have to drive all over creation to find someone who can do this? Any tips on what to ask when I call around so I don't waste time showing up somewhere that can't help me? …more

Read answer

Loading more Q&A...

You've seen all 69 Q&A articles!