Results for "chassis ground"

Engine Hard 4-6 hours 310 👍 0

Ford F53 7.5L RV Won't Start: Fuel Pump Relay Voltage Drop Fix

Woke up to my 1996 Ford F53 7.5L motorhome eating through my patience and wallet with this no-start issue that keeps coming back. It cranks strong but absolutely will not start, and I've been chasing this problem for weeks now. The engine ran fine for about 3-4 minutes one day, then just died and hasn't started since.

I've already done quite a bit of diagnostic work:
- Replaced PCM and distributor
- Fuel pump works when powered directly
- Battery is fully charged
- Checked fuses and relays
- PCM relay voltage drops from 12.2V to 9.3V with key on
- Fuel pump relay only shows 3.3V at pin 86 (should be 12V)
- Inertia switch tested at 1.7V at connector
- ANL 178 fusible link fluctuates between 0.3-0.6V

The engine will only start with starter fluid when the SPOUT is removed. I'm getting only 5.5V at the fuel pump connector.

Has anyone dealt with this specific issue on an F53 chassis? I really need to get this RV back on the road and I'm running out of ideas! …more

Read answer

Electrical Medium 2-6 hours 295 👍 1

ECM Low Battery Warning RV: Complete Diagnosis & Fix Guide

During a family trip, my 2005 Fleetwood Discovery 39S threw code 168-1 for low ECM battery voltage and went into full shutdown mode—is this dangerous with kids onboard? Engine cut out, transmission selector went dark, ABS warnings everywhere - the whole nine yards. Scared the heck out of me when it happened on the interstate!

I'm seeing this seems to be a thing with these diesel pushers, but I'm drowning in conflicting info online. Some say it's the chassis battery, others blame alternator issues, and I've even seen posts about ECM power supply problems on the Caterpillar engines. What's the actual step-by-step process to track this down? And more importantly, how do I fix it so it doesn't leave me stranded again? Really need a complete walkthrough of what causes this code and the proper repair approach. …more

Read answer

Engine Easy 45 min 248 👍 0

Femco vs Fumoto Oil Drain Valves for RVs - Which is Better?

Looked at my mechanic's quote for a $300 professional oil change setup and something seems off—wouldn't a basic Femco or Fumoto drain valve work just fine? I've narrowed it down to Femco and Fumoto, but I'm genuinely worried about road debris damage since RVs sit lower and encounter more hazards than regular vehicles.

The thought of a drain valve getting hit by rocks or debris and causing a catastrophic oil leak on the highway keeps me up at night. I need to know which design is actually safer and more protected in RV applications. Does one have better protection features than the other? I'd rather be overly cautious than deal with a roadside emergency. …more

Read answer

Product Ranking 8 compared

Best RV Propane Accessories

4.5 (11,200 reviews)

Electrical Medium 30-90 min 190 👍 0

No 12 Volt Power in RV: Complete Troubleshooting Guide

Turned the key and nothing works on 12 volt — no lights, no water pump, no slides. Batteries show 12.6 volts on the multimeter so they're fully charged. House batteries seem fine but zero power is getting to any of the 12V circuits inside the coach. …more

Read answer

Electrical Medium 30 min read 182 👍 0

RV DC Electrical System: Expert Guide to 12 Volt Systems

Opened my RV this morning to find the 12V system going haywire — lights dimming randomly, fans slowing down, and the inverter shutting off despite full batteries.

Specifically, I need to understand the fundamentals of RV batteries - different types, proper sizing, charging requirements, and maintenance. I'm also confused about DC wiring best practices, what gauge wire to use for different applications, how to properly route and protect circuits, and where fuses and breakers should go. Voltage monitoring is another area where I'm lost - I see all these battery monitors and don't know what I actually need or how to interpret the readings.

I'm also planning some system upgrades down the road like adding solar or upgrading to lithium batteries, so I'd love to understand how all these components work together and what I need to consider for future modifications. Is there a comprehensive resource that covers all aspects of RV DC electrical systems from batteries and wiring through monitoring and upgrades? …more

Read answer

Electrical Easy 30 minutes 173 👍 0

RV 12V Lights Dimming: Complete Troubleshooting Guide

My neighbor insists it's the converter, the RV dealer swears it's bad wiring, and every YouTube video claims it's a dying battery—but my 12V ceiling lights keep dimming! One evening they're blazing bright like a casino, the next morning they're giving off all the enthusiasm of a sleepy firefly.

I've already checked my batteries, and they seem to be charging fine and in good shape. The converter is still humming and its fan is running normally. I'm pretty sure this isn't some fancy mood lighting feature I accidentally activated (though knowing my tech skills, anything's possible). The dimming seems totally random - sometimes they're fine, sometimes they look like they're on their last legs.

I've got a basic multimeter that I pretend to know how to use, but I'm not sure where to even start poking around. As a bonus weirdness, some of my under-cabinet light switches and the wall switch for the ceiling lights are getting really hot. Anyone know what typically causes this whole disco light show situation with 12V lighting systems? …more

Read answer

Solar Batteries Medium 2-4 hours 168 👍 0

RV Battery Draining Overnight? Find & Fix Parasitic Drain

The day after I installed that new solar charge controller last month, my RV batteries started mysteriously draining from fully charged to completely dead overnight. I've already confirmed that all visible lights, fans, and appliances are turned off, and I've switched off the main interior power, but something is still drawing power continuously. I understand this is likely a parasitic drain where some component or circuit is staying energized when it shouldn't be, but I'm not sure how to systematically track down which specific circuit is causing the problem. I have a basic multimeter but I'm not entirely sure about the proper methodology for testing each circuit individually to isolate where exactly the power draw is coming from. What's the step-by-step process for using a multimeter to methodically work through the electrical system, starting from the main disconnect and testing individual fuses or circuits until I can pinpoint the exact source of this parasitic drain? …more

Read answer

Solar Batteries Medium 45 minutes 158 👍 0

RV MPPT Solar Controller E1 Error Code: Causes & Fixes

Halfway through troubleshooting my MPPT solar charge controller's E1 error — would this be covered under warranty, or am I stuck paying out-of-pocket? The controller was working fine for months, but now it's completely stopped charging my batteries and just displays this E1 fault code on the screen.

From what I've read, this could be related to battery over-voltage conditions or possibly some kind of wiring fault, but I want to make sure I understand all the potential causes before I start troubleshooting. I'm comfortable doing basic electrical work myself, but I also want to know when this might be something that requires professional attention for safety reasons.

Can someone provide a detailed breakdown of what the E1 error specifically indicates, walk me through the proper diagnostic steps to identify the root cause, and explain the repair process? I'd especially appreciate guidance on how to safely approach this troubleshooting and what warning signs would indicate I should call in an expert instead of attempting the fix myself. …more

Read answer

Appliances Hard 8-16 hours 157 👍 0

Entegra Odyssey 26M Murphy Bed Couch Replacement and Ground Clearance Upgrade

Our 2022 Entegra Odyssey 26M's Murphy bed couch just completely failed at 11 PM and we desperately need a replacement solution before family arrives tomorrow morning. What if I could swap out that murphy bed couch for some fancy theater seats? I'm picturing myself reclining in luxury while Netflix loads at dial-up speeds thanks to campground wifi.

But here's where my engineering expertise (aka zero knowledge) kicks in - can theater seats even work with a murphy bed setup? Do the backs need to come off or fold down? And while I'm dreaming big, I'd also love to get a couple more inches of ground clearance so I stop scraping on every driveway entrance like I'm driving a lowrider.

Am I asking for the impossible, or is there actually a way to make this couch-to-theater-seat transformation happen? And what's the least complicated way to get this thing sitting a bit higher off the ground? …more

Read answer

Engine Easy 15 minutes 142 👍 0

5 Star Tuner X4 for Ford V10 RV: Complete Performance & Upgrade Guide

Planning to tune my 2018 Ford 6.8L V10 RV but got quoted $800 for professional tuning and wondering if the 5 Star X4 is DIY-friendly. Specifically want to know about real-world performance improvements - does it actually improve throttle response and shift points? What about fuel economy gains?

Which of the 3 programs works best for RV towing? Is the investment worth it for better drivability or just hype? …more

Read answer

Electrical Medium 1-2 hours 134 👍 0

Ford F53 RV Chassis: All Headlights Out - Complete Diagnosis & Repair

Pulled out my multimeter on this dead F53 headlight situation and I'm getting 12.4V at the relay when every Ford manual says it should read 12.6V. My 1999 Mountain High Pinnacle Class A with 76,000 miles on a Ford F-53 chassis has me stumped - ALL four headlights (both high and low beams) just went completely dead, but here's the weird part: every single other light works perfectly. Taillights, brake lights, turn signals, markers - they're all fine.

When the headlight switch is on, there are no headlights at all, and the blue high beam indicator remains constantly lit. I noticed a strange clicking sound from under the hood about every 20-25 seconds, which continued even after disconnecting the coach and chassis batteries.

I've already replaced the headlight switch thinking that was the culprit, but the same problem persists. No headlights whatsoever when I flip the switch, whether I'm on high or low beam. I'm starting to think it might be the combination switch or maybe a relay with a potential dead short, but I don't want to start throwing parts at this thing without some guidance.

Has anyone dealt with this exact scenario on a late 90s Ford chassis? What should I be checking first? I really need to get this sorted out before my next trip. …more

Read answer

Product Ranking 8 compared

Best RV Awnings & Accessories

4.5 (7,600 reviews)

Chassis Medium 45 minutes 133 👍 0

Dutchstar Chassis Cracking Noise: Diagnosis & Repair Guide

Hearing a loud cracking or popping noise from underneath my Dutchstar when going over bumps or turning. Sounds structural — like metal flexing or a weld breaking. Crawled under and couldn't see any obvious cracks but the noise is getting louder each trip. …more

Read answer

Slideouts Hard 4-8 hours 133 👍 0

How to Lift RV Slideout for Floor Repair - Safe Methods

Apparently my 2000 Allegro Bus slideout only starts sagging and needing floor repair when it hits 85 degrees outside — works perfectly fine otherwise. We discovered water damage under the slideout and need to replace some plywood subflooring, but there are screws I can only access if I lift the slide somehow.

I'm worried about damaging the slideout mechanism or worse, having it fall and hurt someone. The hydraulic system seems to work fine, but I've heard you shouldn't trust it alone for this kind of work. What's the safest method to lift and support a slideout while doing floor repairs underneath? I want to make sure I'm not making a dangerous mistake here. …more

Read answer

Propane Easy 15 min read 131 👍 0

RV Auto Hold Parking Brake: Complete Guide to Operation and Troubleshooting Basics

Woke up this morning and spotted my 1999 Damon Daybreak 3270's auto hold parking brake light blinking on the dash when it was perfectly fine yesterday. I'm still learning everything about motorhome systems and I'm confused about the auto hold parking brake feature.

The system doesn't seem to be working properly (barely holds at all), but honestly I'm not even sure I understand how it's supposed to operate in the first place. Is this something that engages automatically? Do I need to do something specific to activate it?

Could someone explain how these auto hold parking brake systems work on motorhomes, how to use them properly, and maybe some troubleshooting tips? I want to make sure I understand the basics before I start trying to fix anything. …more

Read answer

Engine Medium 1-2 hours 130 👍 0

Ford F53 V10 Bypass Oil Filter Installation: Best Mounting Locations for RV Chassis

Walked out to check my oil analysis results and they're showing 15-micron contaminants, but everything says my 2003 F53 V10's factory filter catches down to 25 microns. I've been reading about how these can help extend oil life and keep things cleaner, but I'm honestly not sure where the best place to mount one would be.

I've seen some people mention sandwich adapters at the original filter location, remote mounting blocks, and even tapping directly into the engine block. As someone who's still learning, I don't want to mess this up or create problems down the road. What's considered the best practice for mounting location on the F53 V10? I'd really appreciate some guidance from those who have done this before. …more

Read answer

Loading more Q&A...

You've seen all 140 Q&A articles!